Dimensions : 140 x 150 x 86mm
Application : Desktop
Watt : 300W


This specification describes a 300 watts power supply. With 6 output, and remote ON/OFF control for ATX-12V system and a “Power factor correction (active PFC)” circuit at 100V-240Vac.



Model Name FSP300-60EGA
Wattage 300W
Dimension 140mm (L) × 150 mm (W) × 86mm (H)
Product Highlight Efficiency Level 80Plus Gold
Erp Lot <0.5W
Input Voltage 100~240Vac
General Specification Effciency 87%@ 20% load; 90%@ 50% load; 87%@ 100% load
PWOK Delay Time 500ms > PWOK > 100ms
EMC performance EN55022 class B
EN 61000-3-2
EN 61000-3-3
Input Electrical Specification Input Frequency 47 ~ 63 Hz
Input Current 115V@ < 6.0 Amps - rms
230V@ < 3.0 Amps - rms
Output Specification Hold-up time 115V/60Hz 17mSec. Minimum@100% Load,
Output Rise Time +3.3V 20mS (maximum)
+5V 20mS (maximum)
+12 V 20mS (maximum)
-12 V 20mS (maximum)
Environmental Requirement Temperature Range Operating : 0 to +40℃
Storage :-40 to +70℃
Humidity Operating : 85% to % RH, Non-condensing
Storage : 95% to % RH, Non-condensing
MTBF The power supply reliability, when calculated by “Bellcore” latest revision are exceed 100,000 hours with all output at maximum load and an ambient temperature of 25℃.

Output Voltage and Current Rating

+3.3V +5V +12V1 +12V2 -12V +5Vsb
Ripple-Noise(R-P) mV 50mV 50mV 120mV 120mV 200mV 50mV
Regulation Load % ±5% ±5% ±5% ±5% ±10% ±5%
Output Max.(A) 16A 16A 18A 18A 0.3A 3A
Output Min.(A) 0.1A 0.2A 0.1A 0A 0A 0A


(1) +3.3V & +5V total output not exceed 90W.
When +5V is load to 16A, the +3.3V maximum load is 3.0A.
When +3.3V is load to 16A, the +5V maximum load is 7.4A.
(2) +12V1 & +12V2 total output not exceed 288W(24A).
(3) All outputs shall be safety-isolated from the AC mains and share a common return. This common return must be connected to supply chassis.
(4) Voltages and ripple are measured at the load side of mating connectors with a 0.1uF monolithic ceramic capacitor paralleled by a 10uF electrolytic capacitor across the measuring terminals.


Contact us

Web Analytics